Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Stair geometry

Tread blank depth

D=g+p+e
where
D
blank depth (mm)
g
going (mm)
p
nosing projection (mm)
e
rear engagement (mm)
Explain this equation

Gives the depth of timber needed for a stair tread from the going, the nosing projection and the rear engagement.

g is the going, the horizontal distance between neighbouring nosings, in millimetres. p is how far the nosing overhangs the riser below. e is how much the tread runs into the riser or housing at the back. D is the blank depth to cut.

The going is measured nosing to nosing, so the actual tread is longer by the overhang at the front and the engagement at the back. Adding the three together gives the board depth.

A 250 mm going with a 25 mm nosing and 10 mm engagement needs a 285 mm blank.

Watch out: the going is not the same as the tread board depth. Use the actual joint and nosing details.

Add a specified nosing projection and rear engagement to a going.

mm
mm
mm

Enter your values to see the result.

Good to know

Use the actual stair joint and nosing design. Going is the horizontal distance between adjacent nosing lines, not necessarily the timber tread depth.

Limits

Stair going is measured horizontally between nosing lines. Building guidance differs across UK nations. Stair geometry must be checked against the applicable nation, building use and project requirements.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A tread with a 235 mm going, an 18 mm nosing projection and 12 mm engagement into the riser housing at the back: D = 235 + 18 + 12 = 265 mm. Boards of at least 265 mm finished width are needed, so check the planed width of the stock, not its nominal size.

Common questions

How much nosing projection should I allow?
Follow the stair design and the rules that apply to it; the projection affects both the look and how comfortable the step is to use. Keep it the same on every tread.

What does rear engagement cover?
The depth the tread runs into a riser groove or housing behind it. If the riser sits on top of the tread instead, it may be zero, so check the joint detail.

Can I edge-joint narrower boards to make up the depth?
Often, yes, if they are well glued and the grain is matched. Make the blanks slightly oversize and plane them to the final depth after the glue has set.

Scroll to Top
Secret Link