Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Stair geometry

Stair pitch-line segment

s=r2+g2L=ns
where
s
one interval length (mm)
r
rise per step (mm)
g
going per step (mm)
L
pitch-line length (mm)
n
going intervals
Explain this equation

Gives the length along the pitch line of a stair for a set number of steps, useful when marking out a string.

r is the rise and g the going of one step, in millimetres. s is the sloping length of one step along the pitch line. n is the number of going intervals. L is the total pitch-line length.

One rise and one going make a right-angled triangle whose hypotenuse lies on the pitch line, so s = √(r² + g²) by Pythagoras. Identical steps simply repeat that length n times.

A 200 mm rise and 250 mm going gives about 320 mm per step. Twelve steps give about 3842 mm.

Watch out: this is not the full string length. Extensions at top and bottom, housings and joints are extra.

Calculate a pitch-line segment spanning a known number of identical going intervals.

mm
mm

Enter your values to see the result.

Good to know

Intervals are explicit. This is not a full string blank length; top/bottom extensions, housings, joints and landings are separate.

Limits

Stair going is measured horizontally between nosing lines. The pitch-line segment tool uses an explicit number of going intervals; it does not silently equate a full floor-height diagonal with a string blank. Building guidance differs across UK nations. Stair geometry must be checked against the applicable nation, building use and project requirements.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

Marking out a string for 13 going intervals at a 185 mm rise and 245 mm going: s = √(185² + 245²) ≈ 307 mm; L = 13 × 307 ≈ 3991 mm along the pitch line. Add the top and bottom extensions and joints to that before choosing a 4.8 m board for the string.

Common questions

Why use the pitch-line length when marking out?
It lets you check your step marks along the string. After marking all the steps with a pitch board or square, the distance along the pitch line should match this figure; if it does not, an error has crept in.

Is the number of intervals the same as the number of risers?
No. A straight flight usually has one fewer going than risers, so count the goings you are marking on the string, not the risers.

Does rounding the single interval matter?
Yes, over many steps. Mark cumulative positions from one end using the full figure rather than stepping off a rounded 307 mm thirteen times.

Scroll to Top
Secret Link