Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Stair geometry

Riser count from a specified maximum

N=⌈Hrmax⌉r=HN
where
N
risers
H
total finished rise (mm)
rmax
specified maximum rise (mm)
r
actual rise (mm)
Explain this equation

Finds the fewest risers needed to climb a height without any rise exceeding a set maximum, and the resulting equal rise.

H is the total finished rise in millimetres. rmax is the largest rise allowed. N is the number of risers, and r the actual rise of each.

Dividing the height by the maximum and rounding up with ⌈ ⌉ gives the least number of steps that keeps every rise within the limit. The height is then shared equally between them.

2600 mm with a 220 mm limit needs 12 risers of about 216.7 mm. Lowering the limit to 200 mm needs 13 risers of exactly 200 mm.

Watch out: the maximum rise is your project input, not a legal value. Also check the minimum rise, going and pitch.

Find a whole riser count not exceeding a supplied maximum rise.

mm
mm

Enter your values to see the result.

Good to know

The maximum is a project input, not an automatic legal recommendation. Also check minimum rise, going, pitch and all other stair provisions.

Limits

Stair going is measured horizontally between nosing lines. Building guidance differs across UK nations. Stair geometry must be checked against the applicable nation, building use and project requirements.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A loft conversion stair with a total finished rise of 2735 mm and a project maximum rise of 210 mm: risers = ceil(2735 ÷ 210) = 14, actual rise = 2735 ÷ 14 ≈ 195.4 mm. With the riser count fixed, choose the going to suit the floor space and then check the pitch.

Common questions

Why is the actual rise well below my maximum?
Rounding up to a whole riser shares the height across one more step than the bare division. Here 13 risers would have been about 210.4 mm, just over the limit, so it has to be 14.

Should I add a riser to get a gentler stair?
You can. Each extra riser lowers the rise but adds another going, so the stair takes up more floor length. Try one either side of the result and see which suits the space and headroom.

Where should I measure the total rise?
From the finished floor at the bottom to the finished floor at the top, at the position of the stair. Floors in older houses are often out of level, so measure where the flight will actually land.

Scroll to Top
Secret Link