Bench joinery
Dovetail slope angle
- where
- angle from the reference axis (°)
- slope denominator (1:n)
Explain this equation
Converts a dovetail slope given as a 1:n ratio into an angle, for setting a bevel or marking gauge.
n is the slope denominator. A 1:6 slope moves 1 unit across for every 6 units along. θ is the angle of the tail side measured from the reference line, in degrees.
The ratio defines a right-angled triangle with sides 1 and n. The angle opposite the side of 1 is arctan(1/n).
1:6 is about 9.5°, 1:8 about 7.1° and 1:5 about 11.3°. A bigger n gives a shallower angle.
Watch out: this is only a marking conversion. It does not recommend a slope for any timber.
Convert a rise-to-run slope of 1:n to an angle.
Enter your values to see the result.
Good to know
This is a marking angle, not a recommendation of slope for a timber species or loading.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Marking through dovetails at a slope of 1:7: θ = atan(1 ÷ 7) ≈ 8.1° from the reference line. To set a sliding bevel without a protractor, mark a line 7 units along the edge and 1 unit across, and set the bevel to the line joining them.
Common questions
How do I set a bevel to 1:7 without a protractor?
Square a line across a board, measure 7 units along it and 1 unit across, and join the points. Set the bevel blade to that line; the ratio works with any unit.
Is the angle measured from the edge or the end of the board?
From the reference line along the grain of the tail board, which is the line the tails run along. Mark it the same way every time so all the tails match.
Does the slope have to be exact?
Consistency matters more than the exact figure. Use the same bevel setting for every tail in the joint, as the pins are marked from the tails.