Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Bench joinery

Centred tenon shoulders

s=T−t2
where
s
shoulder (mm)
T
stock thickness (mm)
t
tenon thickness (mm)
Explain this equation

Works out the shoulder depth each side of a centred tenon.

T is the stock thickness and t the specified tenon thickness, both in millimetres. s is the depth of the shoulder cut on each face.

Whatever is not tenon is removed equally from both faces so the tenon sits in the middle. That means half of T − t from each side.

45 mm stock with a 15 mm tenon has 15 mm shoulders each side. Often the tenon is about a third of the stock thickness, which leaves three equal parts.

Watch out: the tenon thickness comes from the joint design. Fit allowances, haunches and length are not worked out here.

Calculate equal shoulders around a specified central tenon.

mm
mm

Enter your values to see the result.

Good to know

Tenon thickness is chosen from the joint design. Fit allowances, haunches, length and strength are not inferred.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A door rail 44 mm thick, with the tenon sized to suit a 12 mm mortise chisel: s = (44 − 12) ÷ 2 = 16 mm on each face. Set the mortise gauge pins to the chisel width and the stock to 16 mm, and mark both the mortise and the tenon from the same face side.

Common questions

Why size the tenon to a chisel?
Chopping a mortise is easiest when it is exactly one chisel wide, so carpenters often set the tenon thickness to match a chisel they own and cut the tenon to fit the mortise.

What if the stock is not exactly the thickness I expect?
Measure it, and gauge both pieces from the face side. Then the joint is centred on the real timber and the faces still line up even if the stock varies slightly.

Should the shoulders be the same on all four sides?
Not necessarily. The face shoulders are set by this calculation, but the edge shoulders depend on the joint design, for example a haunch at the end of a frame.

Scroll to Top
Secret Link