Cutting & joints
Equal half-lap depth
- where
- recess depth (mm)
- member thickness (mm)
- remaining thickness (mm)
Explain this equation
Gives the recess depth for a flush half-lap joint between two members of equal thickness.
t is the member thickness in millimetres. d is the depth of material removed from each piece. tr is the thickness left in the lapped part.
For the faces to finish flush, each member gives up half its thickness. Two halves overlap to make up one full thickness.
A 44 mm member is cut 22 mm deep, leaving 22 mm. Thicker stock simply scales the cut in proportion.
Watch out: this is the nominal depth only. It does not check whether a lapped joint is strong enough for a structural member.
Calculate the nominal recess depth for equal-thickness members.
Enter your values to see the result.
Good to know
Equal-thickness flush half lap only. Does not verify joint strength, fasteners or suitability for structural members.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
A cross-halving joint where two 63 mm thick bench rails cross: d = 63 ÷ 2 = 31.5 mm recess in each, leaving 31.5 mm. Set the marking gauge from the same face on both pieces so any small error cancels and the faces still finish flush.
Common questions
Why gauge from the same face on both pieces?
If the stock is not exactly the stated thickness, gauging both from their show faces keeps those faces flush even if the halving is slightly off centre.
Does this work for timbers of different thickness?
Not directly. With unequal timbers decide which faces must be flush and work out the recess in each piece from that; this calculator assumes equal thickness.
Should I use the nominal or actual thickness?
The actual thickness measured with a rule or calliper. Planed timber is usually thinner than its sawn size, and the recess must suit the real piece.