Bench joinery
Router guide-bush offset
- where
- offset (mm)
- bush outside diameter (mm)
- cutter diameter (mm)
Explain this equation
Gives the offset between a template edge and the routed cut when using a guide bush.
Db is the outside diameter of the guide bush and dc the diameter of the cutter, both in millimetres. o is the radial offset: how far the cut lies from the template edge. The calculator also shows twice that, which is the overall size difference across an opening or shape.
The bush rubs against the template and the cutter runs concentrically inside it. The gap between the bush edge and the cutter edge is half the difference in their diameters.
A 30 mm bush with a 12 mm cutter gives a 9 mm offset. An opening routed from a template would be 18 mm smaller overall.
Watch out: inside and outside templates need the offset in opposite directions. Check that the bush is properly centred.
Calculate the radial offset between guide bush and cutter.
Enter your values to see the result.
Good to know
Use actual compatible diameters and a concentric bush. Internal and external templates require opposite offsets; check against the drawing.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Routing a recess for a hinge plate from a template, using a 17 mm guide bush and an 8 mm straight cutter: o = (17 − 8) ÷ 2 = 4.5 mm, so the recess comes out 9 mm smaller overall than the template opening. To get a 60 mm wide recess, the template opening needs to be 69 mm.
Common questions
Do I add or subtract the offset when making a template?
For an opening (an internal template) make the template bigger than the finished cut by twice the offset. For an outside shape, make it smaller by twice the offset.
Should I measure the bush and cutter or trust the markings?
Measure them with a calliper. Cutters are often slightly under their nominal size, especially after sharpening, and that changes the offset.
Why is my routed shape off-centre from the template?
The bush is probably not concentric with the cutter. Most bases have a centring cone or pin to set it; check before relying on the template.