Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Second fix

Architrave: three-sided long points

lleg=H+r+tlhead=W+2(r+t)
where
lleg
leg long point (mm)
H
opening height (mm)
r
reveal (mm)
t
trim face width (mm)
lhead
head long point (mm)
W
opening width (mm)
Explain this equation

Gives the long-point lengths of architrave for a square, mitred door or window surround: two legs and a head.

H and W are the opening height and width in millimetres. r is the reveal, the step back from the lining edge. t is the face width of the architrave. lleg and lhead are the long-point lengths, measured on the outer edge of each mitre. The calculator also totals the cut length for one or two faces.

Each leg runs the opening height, plus the reveal, plus the head's width where it meets the mitre. The head spans the opening plus a reveal and a trim width on each side, hence the 2(r + t). The 45° mitres make the long point exactly one trim width beyond the inner line.

An 838 × 1981 mm opening with a 5 mm reveal and 70 mm architrave gives 2056 mm legs and a 988 mm head. Both sides take about 10.2 m.

Watch out: this assumes a square frame, 45° mitres and equal trim widths. Out-of-square openings need marking off in place.

Calculate two legs and a head for a square, mitred frame with equal-width architrave.

mm
mm
mm
mm

Enter your values to see the result.

Good to know

Measured from floor/base to opening head and across opening. Assumes 45° mitres, equal trim width and square frame. Scribed or unequal-width details need their own layout.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

Trimming one face of a metric door lining with a clear opening of 826 × 2040 mm, a 6 mm reveal and 58 mm architrave: leg = 2040 + 6 + 58 = 2104 mm; head = 826 + 2 × (6 + 58) = 954 mm; total cut length about 5.16 m. One 2.1 m length per leg is not quite enough, so legs need stock of at least 2104 mm plus trimming.

Common questions

Why measure to the long point?
The long point is the outer tip of the mitre, the easiest place to mark and measure on the board. Measure and mark it, then cut the mitre back towards the short point.

What if the floor is out of level across the doorway?
Cut each leg to suit its own side, measuring from the floor to the reveal mark at the head. The calculator gives a starting length; scribe the bottom of each leg to fit.

What reveal should I leave?
Pick a small, even reveal that suits the hinge side and the look you want, and mark it on the lining edge before fixing. Keeping it equal all round matters more than the exact size.

Scroll to Top
Secret Link