Second fix
Door leaf clearance arithmetic
- where
- leaf width (mm)
- opening width (mm)
- left and right gaps (mm)
- leaf height (mm)
- opening height (mm)
- top and bottom gaps (mm)
Explain this equation
Works out the door leaf size that leaves specified gaps all round within a measured lining opening.
W and H are the opening width and height in millimetres. gl and gr are the gaps at the hanging and closing sides. gt is the gap at the head, and gb the gap at the bottom, often bigger to clear floor coverings. wleaf and hleaf are the leaf sizes.
The leaf plus the gaps on both sides fills the opening, so you just subtract the gaps from each dimension.
An 838 × 1981 mm opening with 3 mm gaps at the sides and head and 8 mm at the bottom gives a 832 × 1970 mm leaf.
Watch out: this does not authorise trimming a door. Fire, smoke, security and acoustic doorsets have certified gap limits and trimming rules.
Deduct specified operating clearances from a measured lining opening.
Enter your values to see the result.
Good to know
Does not authorise trimming. Fire, smoke, security and acoustic doorsets require their certified instructions, gap limits and permitted trimming.
Limits
Flooring gaps, slide clearances, fire-door gaps, fixing schedules and finishes must follow the design and product instructions.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Hanging a new leaf in an existing lining 832 × 2050 mm, with 3 mm gaps at both sides and the head and 12 mm at the bottom to clear a new carpet: leaf width = 832 − 3 − 3 = 826 mm; leaf height = 2050 − 3 − 12 = 2035 mm. A standard 826 × 2040 mm metric leaf would need only 5 mm off the height.
Common questions
Should I measure the opening in more than one place?
Yes. Measure the width at the top, middle and bottom and the height at both sides. Use the smallest figures, then plane to suit if the lining is out of square.
Where should I take height off a door?
Usually from the bottom, unless the door maker says otherwise. Check how much can be removed from each edge before cutting, as many doors have limited solid timber at the edges.
How big should the bottom gap be?
It depends on the floor finish, any threshold and whether the room needs an air gap under the door for ventilation. Decide that before cutting.