Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Second fix

Skirting / perimeter trim

Lnet=2(L+W)−D+RLo=Lnet(1+w100)
where
Lnet
net trim length (m)
L
room length (m)
W
room width (m)
D
deductions (m)
R
additional returns (m)
Lo
order length (m)
w
waste (%)
Explain this equation

Gives the length of skirting or other perimeter trim for a rectangular room, then an order length and a rough count of stock lengths.

L and W are the room length and width in metres. D is the total length deducted for doorways and other gaps. R is the total length added for returns, such as round a chimney breast. Lnet is the net trim, w the waste percentage and Lo the order length.

2(L + W) is the room perimeter. Deductions are subtracted and returns added to get the trim actually fixed. Waste is applied as (1 + w/100). The stock count is the order length divided by the stock length, rounded up.

A 5 × 4 m room has an 18 m perimeter. Less 0.9 m for a door and plus 0.2 m of returns, it is 17.3 m. With 10% waste that is 19.03 m, or five 4.2 m lengths.

Watch out: the stock count is a total allowance, not a cutting plan. Walls longer than one stock length need joints.

Calculate linear trim from a rectangular room after deductions and returns.

m
m
m
m
%
m

Enter your values to see the result.

Good to know

Deductions and returns are total lengths in metres. Stock count is an aggregate allowance, not a cut plan; check each wall run and joint locations.

Limits

Skirting stock allowances do not guarantee every run can be cut from those stock lengths.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A dining room 4.35 × 3.6 m with two doorways totalling 1.75 m, a chimney breast adding 0.7 m of returns, 12% waste and 4.8 m stock lengths: Lnet = 2 × (4.35 + 3.6) − 1.75 + 0.7 = 14.85 m; Lo = 14.85 × 1.12 ≈ 16.6 m, an aggregate allowance of 4 lengths. Check the 4.35 m walls can each come out of one length, so there are no joints on the longest runs.

Common questions

Why might four lengths not be enough in practice?
The count only divides the total by the stock length. If the offcuts are too short to use on any wall, you may need an extra length, so plan which piece goes on which wall.

How much waste should I allow for skirting?
Rooms with many short runs, mitres and returns waste more than a plain rectangle. Allow more when the stock length is only slightly longer than the walls, as the offcuts are less useful.

Should I deduct the full door opening?
Deduct the width the skirting actually stops at, which is usually the outside of the architraves, not the lining. Measure it at each door.

Scroll to Top
Secret Link