Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Setting out

Fall from a 1:n gradient

f=xn×1000L2=L1−xn
where
f
fall (mm)
x
horizontal run (m)
n
gradient denominator (1 in n)
L₂
end level (m)
L₁
start level (m)
Explain this equation

This gives the fall over a run from a gradient written as 1 in n, and the level at the far end. Use it for paving, drainage channels, thresholds or anything laid to a fall.

x is the horizontal run in metres. n is the gradient denominator, so 1 in 80 means n = 80. f is the fall in millimetres. L₁ is the starting level and L₂ the level at the end of the run, both in metres.

A 1 in n gradient drops one unit for every n units across, so the fall over x is x / n. The × 1000 shows the fall in millimetres; the end level is worked in metres, so it uses x / n without that factor.

A 5 m run at 1 in 80 falls 62.5 mm, so a 10.000 m start level ends at 9.9375 m. Halving n, to 1 in 40, doubles the fall.

Watch out: the calculator assumes nothing about what fall is required. Take the gradient from the specification for that detail.

Calculate a vertical fall from a specified horizontal distance and gradient.

m
m

Enter your values to see the result.

Good to know

Use the fall specified for the particular detail. No universal paving, DPC or drainage fall is assumed.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

A patio runs 3.6 m out from the house and is laid to fall away from the wall at 1 in 60, starting at 45.230 m at the house end. f = 3.6 ÷ 60 × 1000 = 60 mm, so L₂ = 45.230 − 0.060 = 45.170 m. Set the string lines to those two levels and the slabs will shed water away from the building.

Common questions

How do I set a fall with a spirit level and straight edge?
Fix a packer of the right thickness under one end of the straight edge, for example 25 mm under a 1.5 m edge for 1 in 60, and lay until the bubble is central. It is quicker than working out each level separately.

Which direction should a patio fall?
Away from the house, towards a drain, lawn or soakaway edge. If the patio is bounded on all sides, plan the falls to a channel or gully so water has somewhere to go.

The far end comes out below the lawn. What now?
Reduce the run, raise the start level if the damp course allows it, or add a drainage channel to take the water before the low point. Do not raise the house end above the level required below the DPC to make it work.

Scroll to Top
Secret Link