Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Setting out

Level-book calculation

HI=RLknown+BSRLnew=HI−FS
where
HI
height of instrument (m)
RL
reduced level (m)
BS
backsight (m)
FS
foresight (m)
Explain this equation

This reduces staff readings from an optical or laser level to a new reduced level using the height-of-instrument method. Use it to transfer a level from a benchmark to a new point.

RL_known is the reduced level of the benchmark or known point. BS, the backsight, is the staff reading taken on that known point. HI is the height of the instrument's line of sight. FS, the foresight, is the staff reading at the new point, and RL_new is its reduced level.

The staff measures down from the line of sight to the ground. So the line of sight sits BS above the known point, which gives HI, and the new point sits FS below the line of sight, which gives RL_new.

From a 100.000 m benchmark, a 1.200 backsight gives HI = 101.200. A 1.800 foresight puts the new point at 99.400, which is 600 mm lower. A bigger foresight always means a lower point.

Watch out: both readings must be from the same instrument set-up. Close back onto a known level to check your work.

Use a known reduced level and staff readings to find a new reduced level.

m
m
m

Enter your values to see the result.

Good to know

All readings must relate to the same instrument setup. Complete closing checks and record change points separately.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

Transferring a level from a temporary benchmark of 52.475 m on a manhole cover to the top of a footing. The backsight on the TBM reads 1.385 and the foresight on the footing reads 0.920. HI = 52.475 + 1.385 = 53.860 m and RL_new = 53.860 − 0.920 = 52.940 m, so the footing is 465 mm higher than the benchmark. Close back onto the TBM before moving the level to confirm the reading has not drifted.

Common questions

What if I need to move the instrument partway through?
Take a foresight on a solid change point, move the level, then take a backsight on that same point from the new position. Each set-up gets its own height of instrument, carried forward through the change point.

How do I check my readings are right?
Finish by reading back onto the original benchmark or another known level. The sum of backsights minus the sum of foresights should equal the difference between the starting and closing levels.

Does it matter if the staff is not held plumb?
Yes. A leaning staff always reads too high, which makes the point look lower than it is. Use a staff bubble or rock the staff gently and take the lowest reading.

Scroll to Top
Secret Link