Setting out
Drawing scale
- where
- real length (mm)
- drawing length (mm)
- scale denominator (1:n)
Explain this equation
This converts a length measured on a drawing into a real length at a 1:n scale, and the other way round. Use it when a dimension is missing and you have to scale it off a print.
D is the length on the drawing in mm. n is the scale denominator, so 1:50 means n = 50. R is the real length in mm. The calculator also gives R in metres.
At 1:n, one millimetre on paper stands for n millimetres in reality, so the real length is D × n. Working backwards, the drawing length is R / n. The real length in metres is just R divided by 1000.
At 1:50, 40 mm on the drawing is 2000 mm, or 2 m, on site. At 1:100 the same 40 mm would be 4 m.
Watch out: always prefer a written dimension. Prints that have been resized, or measured on a zoomed screen, are no longer at the stated scale.
Convert a measured drawing length at a stated 1:n scale.
Enter your values to see the result.
Good to know
Prefer written dimensions. Check the print calibration; screen zoom and resized prints change the effective scale.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
On a 1:100 planning drawing, an undimensioned side wall measures 37.5 mm with a scale rule. R = 37.5 × 100 = 3750 mm, or 3.75 m. Working back, a 1150 mm window on the same drawing should scale at 1150 ÷ 100 = 11.5 mm, which is a quick way to check the print has not been resized before trusting any scaled figure.
Common questions
How can I tell if a printed drawing is still at scale?
Measure a written dimension or the printed scale bar on the sheet and compare it with what the scale says it should be. If they do not match, the print has been enlarged or shrunk and scaled measurements are unreliable.
Is it acceptable to set out from scaled dimensions?
Avoid it wherever you can. Ask the designer for the missing dimension, because line thickness and print tolerances alone can introduce errors of tens of millimetres at 1:100.
Why do my scaled lengths differ slightly from the figured ones?
Drawings are often not drawn to perfect accuracy, and the written dimension is the one that counts. Where they disagree, work to the figured dimension and query anything that matters.