Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Materials

Timber movement estimate

ΔW=Wc100ΔM
where
ΔW
movement (mm)
W
original width (mm)
c
movement coefficient (% of dimension per percentage point MC)
ΔM
change in moisture content, final − initial (percentage points)
Explain this equation

Estimates how much a board will shrink or swell across the grain when its moisture content changes.

W is the original width in millimetres. c is the movement coefficient: the percentage change in width per one percentage-point change in moisture content. It depends on the species and on radial or tangential grain. ΔM is the final minus the initial moisture content. ΔW is the change in width; positive means swelling.

Within the normal working range, movement is roughly proportional to the moisture change. So the width changes by c% for every point of ΔM. The /100 turns the percentage into a fraction.

200 mm at 0.25% per point going from 12% to 18% swells about 3 mm, to 203 mm. Doubling the width doubles the movement.

Watch out: this is a straight-line estimate that only applies below fibre saturation. It does not replace a manufacturer's expansion gaps.

Estimate across-grain movement using a supplied species/direction coefficient.

mm
%
%
%

Enter your values to see the result.

Good to know

Linear approximation over a suitable moisture range below fibre saturation. Coefficient depends on species and radial/tangential direction. Does not predict engineered flooring or replace manufacturer movement gaps.

Limits

Timber movement requires the actual species/direction coefficient and a suitable moisture range; the example coefficient is not universal.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

An oak board 180 mm wide delivered at 16% moisture content, expected to settle at 10% in a centrally heated house, taking a coefficient of 0.3% per point for this cut: ΔW = 180 × 0.3 ÷ 100 × (10 − 16) ≈ −3.2 mm, so the board would shrink to about 176.8 mm. That is enough to open visible gaps between boards fitted tight at delivery.

Common questions

Where do I get the movement coefficient?
From timber species data, which usually gives separate figures for radial and tangential movement. Quarter-sawn boards move less across the width than flat-sawn ones.

How do I find the moisture content?
Use a moisture meter set for the species, taking readings on several boards and away from the ends. Let timber acclimatise in the room it is going into before fitting where you can.

Does this apply along the length of the board?
No. Movement along the grain is very small and is not what this estimates. It is the width across the grain that changes.

Scroll to Top
Secret Link