Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Materials

Floorboard rows & balanced edges

u=W−2gn=⌈uc⌉e=u−(n−2)c2
where
u
usable width (mm)
W
room width (mm)
g
gap at each wall (mm)
n
row count
c
effective board cover (mm)
e
equal edge-row width (mm)
Explain this equation

Sets out floorboard rows across a room so that the first and last rows are the same width. That avoids leaving a thin sliver against one wall.

W is the room width and g the expansion gap left at each wall. u is the usable width between gaps. c is the effective cover of one board, excluding the tongue. n is the number of rows, and e the width of each of the two edge rows. All are in millimetres.

Taking 2g from the room leaves the width to be filled. Dividing by the cover and rounding up gives the rows needed. Of those, n − 2 are full boards, and the space left over is split equally between the two edge rows.

A 3000 mm room with 10 mm gaps and 150 mm cover leaves 2980 mm and needs 20 rows: 18 full rows plus two edge rows of 140 mm.

Watch out: if only one row is needed, the calculator reports the full usable width. Check the product's minimum rip width.

Set out equal first and last rows across a room.

mm
mm
mm

Enter your values to see the result.

Good to know

Cover width excludes the tongue. For one row the full usable width is reported. Confirm product minimum rip width and support. Expansion gap is a specified input.

Limits

Flooring gaps, slide clearances, fire-door gaps, fixing schedules and finishes must follow the design and product instructions.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A living room 3650 mm wide, laid with boards giving 190 mm effective cover and a 12 mm expansion gap at each wall: usable width = 3650 − 2 × 12 = 3626 mm; rows = ceil(3626 ÷ 190) = 20; edge rows = [3626 − 18 × 190] ÷ 2 = 103 mm. So you lay 18 full rows with a 103 mm ripped row against each wall, rather than a full first row and a thin sliver at the far side.

Common questions

Should I measure the room width in just one place?
No. Measure at both ends and in the middle, because walls are rarely parallel. Work the rows from the narrowest figure and check the edge rows at the widest point, scribing the first row if the wall wanders.

Can balanced edge rows still end up as a thin sliver?
No. Because the row count is rounded up, the leftover is shared between two rows and each edge row comes out between just over half a board and a full board wide.

Do I use the board's full width or its cover width?
Use the cover width, the face you see once boards are joined, without the tongue. Using the full width overstates every row and the error builds up across the room.

Scroll to Top
Secret Link