Cutting & joints
Equal flat mitres at a corner
- where
- cut line to long edge (°)
- included corner angle (°)
- saw setting from square (°)
Explain this equation
Gives the mitre saw settings for two equal-width pieces meeting in a flat corner at any angle, not just 90°.
θ is the included angle between the two finished runs, in degrees. α is the angle the cut line makes with the long edge of each piece. β is the same cut expressed as a saw setting from square, which is how most mitre saws are marked.
For a tight joint between pieces of equal width, each piece takes exactly half of the corner, so α = θ/2. A square cut sits at 90° to the edge, so the saw setting is the difference: 90° − θ/2.
A 90° corner gives 45° and 45°. A 135° corner gives 67.5° to the edge and 22.5° on the saw.
Watch out: θ is the smaller angle between the runs. Measure it with a bevel or angle finder rather than assuming 90°, and test on scrap.
Find equal mitre saw settings for two coplanar pieces at a measured included angle.
Enter your values to see the result.
Good to know
Angle is the smaller included angle between the two finished runs (0–180°). Both pieces have equal width. Saw handedness and waste side depend on the joint; test on scrap.
Limits
Simple mitre settings are from square, not from the long edge.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Running skirting round a 112° corner where a hallway wall angles off: α = 112 ÷ 2 = 56° from the long edge, so the saw setting is 90 − 56 = 34° from square on each piece. Cut both pieces at 34°, offer them up, and adjust by half a degree each if the joint opens at the front or back.
Common questions
How do I measure the corner angle accurately?
Use a digital angle finder or a sliding bevel set against both walls at skirting height, then read the bevel with a protractor. Walls are rarely exactly the angle on the drawing.
Why does my joint open even with the right angle?
The pieces may not be the same width, the wall may not be flat, or the saw may be slightly off its scale. Cut test pieces from offcut and fine-tune before cutting the real lengths.
Is it the same for an internal and an external corner?
The angle settings are the same; what changes is which side of the cut is waste and which way the piece faces the fence. For internal skirting corners many carpenters scribe instead of mitring.