Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Bench joinery

Drawer box between slides

Wbox=O−al−arlb=Wbox−2t
where
Wbox
outside box width (mm)
O
cabinet opening (mm)
al, a_r
left and right slide allowances (mm)
lb
between-side piece length (mm)
t
side thickness (mm)
Explain this equation

Gives the outside width of a drawer box to suit its runners, and the length of the front and back pieces fitted between the sides.

O is the cabinet opening in millimetres. al and ar are the spaces each runner needs, from the slide maker's data. Wbox is the outside width of the box. t is the thickness of each side, and lb the length of a front or back piece that fits between them.

The box fills the opening minus the runner space on each side. The front and back sit inside the two sides, so they are shorter by 2t.

A 600 mm opening with 12.7 mm slides each side gives a 574.6 mm box. With 18 mm sides the front and back are 538.6 mm.

Watch out: use the slide manufacturer's figures and tolerances. Overlay or inset fronts are sized separately.

Calculate box width and a front/back piece fitted between equal sides.

mm
mm
mm
mm

Enter your values to see the result.

Good to know

Use the slide manufacturer’s required clearance, tolerances and drawer system. Does not size drawer depth or inset/overlay fronts.

Limits

Flooring gaps, slide clearances, fire-door gaps, fixing schedules and finishes must follow the design and product instructions.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A kitchen base unit with a 464 mm internal opening, side-mount slides needing 12.5 mm each side and 15 mm birch ply sides: Wbox = 464 − 12.5 − 12.5 = 439 mm; lb = 439 − 2 × 15 = 409 mm. Cut the front and back at 409 mm, plus any extra length your corner joint needs.

Common questions

Where should I measure the cabinet opening?
At the front and back, and at the height where each runner fixes. Carcass sides can bow slightly, so use the smallest reading.

How do I size the drawer bottom?
Work it out separately: if it sits in grooves in the sides, front and back, it is the inside size of the box plus the groove depths, less a small clearance.

What happens if the box is a millimetre or two out?
Side-mount slides often have little tolerance: too wide and the drawer binds, too narrow and it can rattle or come off the runners. Check the slide maker's tolerance and dry-fit before gluing.

Scroll to Top
Secret Link