Setting out
Equal clear gaps / balusters
- where
- equal clear gap (mm)
- clear opening (mm)
- member count
- member width (mm)
- centre pitch (mm)
Explain this equation
Spaces a fixed number of members, such as balusters or slats, so every clear gap is equal, including the gaps at each end.
W is the clear opening between the end posts and b the width of each member, in millimetres. n is the number of members. g is the clear gap, and p the centre-to-centre pitch.
n members sitting in an opening create n + 1 gaps: one at each end and n − 1 between. The members take up nb, and the rest is shared equally across n + 1 gaps. The pitch is one member plus one gap.
8 × 40 mm members in a 1000 mm opening leave 680 mm across 9 gaps, about 75.6 mm each, at about 115.6 mm centres.
Watch out: this is spacing only. It does not check guarding limits, climbability or strength.
Fit full-width members with equal clear gaps at both ends and between.
Enter your values to see the result.
Good to know
Geometric spacing only. Does not check guarding strength, climbability or regulatory opening limits; use the project specification.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Fitting 15 balusters 41 mm wide in a 1740 mm clear opening between newels: g = (1740 − 15 × 41) ÷ (15 + 1) ≈ 70.3 mm; p = 41 + 70.3 ≈ 111.3 mm. Cut a spacer block at 70.3 mm and use it between each baluster instead of measuring every gap from one end.
Common questions
Does the count include balusters fixed against the newels?
No. The calculation leaves a gap at each end, so every baluster sits within the opening. If you want a member tight to each newel, measure the opening between those two members instead.
On a stair, is the baluster width measured square or along the rake?
Along the rake, because a square baluster cut at the pitch is wider along the sloping rail than across its face. Measure it on the rail itself to avoid gaps that creep.
What if the gap does not divide neatly to the millimetre?
Set out from the centre or use a spacer and split any small error across several gaps. A fraction of a millimetre per gap is invisible; letting it build up at one end is not.