Setting out
Equal centres along a member
- where
- pitch (mm)
- length (mm)
- end margin (mm)
- points
- first position (mm)
- last position (mm)
Explain this equation
Positions a set number of points evenly along a length, keeping the same margin at each end. Use it for fixings, holes, brackets or setting-out marks.
L is the overall length and m the end margin, both in millimetres. n is the number of points. p is the pitch between neighbouring points. x1 and xn are the first and last positions, measured from the start.
Taking a margin off each end leaves L − 2m. n points create n − 1 equal intervals, so the pitch is that length divided by n − 1. The first point sits at m and the last at L − m.
1000 mm with 50 mm margins and 6 points gives a 180 mm pitch, at 50, 230, 410, 590, 770 and 950 mm.
Watch out: these are centre positions, not clear gaps. Check minimum edge distances for fixings.
Find positions with equal end margins and a chosen number of points.
Enter your values to see the result.
Good to know
Point positions, not clear gaps. For fixing layouts use the approved edge distances and maximum spacing.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Marking 9 shelf bracket screw positions along a 2400 mm batten with 75 mm end margins: p = (2400 − 2 × 75) ÷ (9 − 1) = 281.25 mm, with the first point at 75 mm and the last at 2325 mm. Mark cumulative positions from one end (75, 356.25, 637.5 mm and so on) rather than stepping off each pitch, so small errors do not add up.
Common questions
Should I use the pitch or cumulative positions when marking out?
Cumulative positions measured from one end are more accurate. Stepping off the pitch with a tape each time lets small errors add up along the length.
What if the pitch must hit studs or joists?
Then the fixings follow the framing rather than an even pitch. Use this calculator for things like holes, brackets and decorative fixings where you can choose the positions.
How do I choose the end margin?
Keep fixings far enough from the ends that the material will not split, as the product or fixing instructions say. Matching the margin to a visible detail, such as a bracket width, often looks neater too.