Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Quantities

Solid volume

V=LHT1000
where
V
volume (m³)
L
length (m)
H
height (m)
T
thickness (mm)
Explain this equation

This gives the solid volume of a rectangular block of material, such as a length of wall, a pier or a slab, when the thickness is in millimetres and the other sizes are in metres.

L is the length and H the height, both in metres. T is the thickness in millimetres, for example 102.5 for a half-brick leaf or 215 for a one-brick wall. V is the result in m³.

Volume is length times height times thickness. Dividing by 1000 turns the millimetre thickness into metres so all three sizes are in the same unit before they are multiplied.

A wall 5 m long, 2 m high and 215 mm thick is 5 × 2 × 0.215 = 2.15 m³. Halve the thickness and the volume halves.

Watch out: this is the gross solid. Cavities, voids and openings must be deducted separately.

Calculate a rectangular solid from metre lengths and millimetre thickness.

m
m
mm

Enter your values to see the result.

Good to know

This is gross solid volume. Deduct cavities or voids separately.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

A 9.2 m long retaining garden wall, 900 mm high, built a brick and a half thick at 327.5 mm. V = 9.2 × 0.9 × 327.5 ÷ 1000 ≈ 2.71 m³ of solid brickwork. That volume is the starting point for the wall's self-weight and, with a typical density, the load it puts on the footing.

Common questions

What thickness should I enter for a cavity wall?
Do not enter the overall wall thickness, as that includes the air gap. Work out each leaf separately, for example 102.5 mm for the brick leaf and 100 mm for the block leaf, and add the volumes.

Can I use this volume to order mortar?
Not directly. Mortar is only the joints, a fraction of the solid volume, so use the mortar calculator or a bricks-per-mortar figure instead.

How do I allow for a coping or capping on top?
Work the coping out as its own block with its own length, height and thickness, then add it on. Copings usually overhang and are a different material, so keeping them separate also helps with weights and costs.

Scroll to Top
Secret Link