Quantities
Two-leaf / cavity-wall quantities
- where
- units to order for leaf i (outer or inner)
- net area of that leaf (m²)
- units per m² for that leaf
- waste (%)
Explain this equation
This works out separate orders for the outer and inner leaves of a cavity wall, each from its own area and its own units per square metre. Use it when the two leaves are built in different units, typically brick outside and block inside.
For each leaf i, A_i is its net area in m² and N_i is how many units it takes per m² (for example about 60 for bricks or 10 for standard blocks). w is the waste percentage, applied to both leaves. Q_i is the number of units to order for that leaf.
Net area times units per m² gives the bare count; (1 + w/100) adds the waste; the ⌈ ⌉ brackets round up to whole units. Each leaf is rounded on its own because they are separate orders.
With 10 m² each side, 60 bricks/m² and 10 blocks/m², 5% waste gives 630 bricks and 105 blocks.
Watch out: the cavity itself is not masonry. The areas of the two leaves can differ because of returns, openings and closers, so measure each one.
Calculate both leaves separately using their specified units per square metre.
Enter your values to see the result.
Good to know
Rates must reflect each leaf, bond and unit. Do not count the cavity as solid masonry. Leave thickness and structural specification to the design.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
A two-storey side extension has 42.6 m² of facing brick outside at 59.3 per m² and 39.8 m² of 440 × 215 block inside at 9.88 per m², with 6% waste on both. Q_outer = ⌈42.6 × 59.3 × 1.06⌉ = 2678 bricks and Q_inner = ⌈39.8 × 9.88 × 1.06⌉ = 417 blocks. The inner area is smaller because it is measured on the inside face, so each leaf gets its own figure rather than copying one area for both.
Common questions
Why is the inner leaf area less than the outer?
The inner face is shorter at every external corner by about the wall thickness, and window and door reveals often take up slightly different areas on each leaf. Measuring each face separately avoids over-ordering blocks.
Should the waste be the same for bricks and blocks?
It does not have to be. Facing bricks are often given a higher allowance for chips and colour selection, while blocks can be cut and used in the wall, so you may want to run the leaves at different rates.
Does this include wall ties, insulation or cavity closers?
No, it only counts the masonry units. Ties, insulation boards, closers, DPCs and lintels are separate take-offs.