Geometry
Circle area & circumference
- where
- area (m²)
- diameter (m)
- circumference (m)
Explain this equation
This gives the area and circumference of a circle from its diameter. Use it for round bases, circular planters, manholes, curved paving or the length of a round wall.
d is the diameter, measured straight across through the centre. A is the area inside the circle and C is the distance around it. π, about 3.1416, is the fixed ratio of any circle's circumference to its diameter.
Circumference is π times the diameter by definition. The area is πr², and since the radius is half the diameter, πr² becomes πd²/4. That is where the 4 comes from.
A 2 m diameter circle has a circumference of about 6.28 m and an area of about 3.14 m². Doubling the diameter doubles the circumference but quadruples the area.
Watch out: on a circular wall the inside face, centreline and outside face each have a different diameter. Use the one that matches what you are measuring or setting out.
Calculate a circular feature from its diameter.
Enter your values to see the result.
Good to know
Use the correct setting-out line: inside, outside or centreline.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
A circular patio with a brick soldier-course edging is set out at 3.6 m diameter. A = π × 3.6² ÷ 4 ≈ 10.2 m² and C = π × 3.6 ≈ 11.3 m. Order sub-base and paving on about 10.2 m², and bricks for an edging course roughly 11.3 m long, plus extras for cutting the tapered joints.
Common questions
How do I set out a circle accurately on site?
Drive a peg at the centre and use a string line or a timber trammel cut to the radius, marking the ground as you swing it round. Keep the centre peg in until the edging is laid so you can recheck.
What diameter do I use for a ring of edging bricks?
Measure to the line you are laying to. The outside of a brick edging is longer than the inside, so for a count based on circumference, use the centre line of the bricks.
How much extra paving should I allow for a round area?
More than for a rectangle, because every unit around the edge is cut on a curve. Allow a generous cutting margin, especially with large slabs.