Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Geometry

Triangle area

A=bh2
where
A
area (m²)
b
base (m)
h
perpendicular height (m)
Explain this equation

This finds the area of a triangle, such as a gable, a raked infill panel or a triangular piece of paving.

b is the base, the side you choose to measure along. h is the perpendicular height, the square distance from the base line up to the opposite corner. A is the area in m².

Any triangle is exactly half of the rectangle or parallelogram built on the same base and height, which is why the product b × h is divided by 2. The shape of the sloping sides does not matter as long as h is measured square to the base.

A 4 m base with a 3 m perpendicular height gives 6 m², half of a 4 × 3 rectangle. Doubling either the base or the height doubles the area.

Watch out: h is not the length of a sloping side. Using the sloping side overstates the area.

Calculate a triangle using its base and perpendicular height.

m
m

Enter your values to see the result.

Good to know

The height must be at right angles to the base, not the sloping side.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

The triangular top of a gable sits on a 6.8 m wide wall at eaves level and rises 2.45 m, measured plumb, to the ridge. A = 6.8 × 2.45 ÷ 2 ≈ 8.33 m². Add that to the rectangular part of the gable below for the brick count, and allow extra for the cut bricks up both rakes.

Common questions

How do I get the height if I can only measure the sloping side?
If you know the sloping length and half the base, the height is √(slope² − half-base²). Measuring plumb from eaves level to the ridge with a tape and level is usually quicker on site.

Does the base have to be the bottom edge?
No. Any side can be the base, as long as the height is measured square to that side. Pick whichever pair is easiest to measure accurately.

What about a triangle that is not symmetrical, like a lean-to gable?
The formula works the same for any triangle; only the base and perpendicular height matter, not where the peak sits along the base.

Scroll to Top
Secret Link