Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Geometry

Rectangle area & perimeter

A=LWP=2(L+W)
where
A
area (m²)
L
length (m)
W
width (m)
P
perimeter (m)
Explain this equation

This gives the area and perimeter of a rectangle, such as a slab, a base, a panel or the plan of a building. Area is used for quantities; perimeter is used for footings, edging, DPC runs and setting-out.

L and W are the two side lengths in metres. A is the space enclosed, in m². P is the distance all the way round the outside, in m.

Area is length times width. The perimeter has two lengths and two widths, so it is 2(L + W).

A 4 m × 3 m base is 12 m² and has a 14 m perimeter. Doubling both sides multiplies the area by four but only doubles the perimeter, which is why larger plans have proportionally less edge.

Watch out: decide which line you are measuring. Outside faces, centrelines and inside faces give different perimeters on a real wall.

Calculate a rectangular plan, base or panel.

m
m

Enter your values to see the result.

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

A single garage base measures 5.4 m × 3.15 m to the outside of the footings. A = 5.4 × 3.15 ≈ 17.0 m² and P = 2 × (5.4 + 3.15) = 17.1 m. Use the area for the slab, sub-base and membrane, and the 17.1 m perimeter as the starting point for the footing run, DPC and edge formwork.

Common questions

Which perimeter should I use for a footing trench?
For quantities in the trench, the centre line of the trench is usually the right length, because using the outside face over-counts the corners. Take the outside perimeter and subtract four trench widths to get it for a simple rectangle.

How do I handle an L-shaped plan?
Split it into two rectangles, add their areas, and measure the perimeter round the outside separately. Adding the two rectangles' perimeters would count the shared line twice.

Should I measure to the brick face or to the render?
Measure to whatever surface the quantity is for: the brick face for bricks, the finished face for render or cladding. Small differences per side add up over a whole building.

Scroll to Top
Secret Link