Quantities
Raking wall / trapezoid
- where
- net wall area (m²)
- length (m)
- heights at each end (m)
- openings (m²)
Explain this equation
This gives the net area of a raking wall: one with two vertical ends of different heights and a straight sloping top, such as a wall stepping up a garden slope or under a lean-to roof.
l is the horizontal length between the two ends. h₁ and h₂ are the heights at each end. A_o is the total area of any openings, subtracted at the end.
Because the top runs in a straight line, the average height of the wall is exactly halfway between the two end heights, (h₁ + h₂) / 2. Multiplying that average by the length gives the area, the same as a rectangle at the mean height. The 2 is just that averaging.
A 5 m wall rising from 1 m to 2 m has an average height of 1.5 m, so 7.5 m². If both ends were 2 m it would be 10 m², a plain rectangle.
Watch out: if the top is stepped, curved or changes slope part way, split the wall into sections and work each one separately.
Measure a straight sloping top between two vertical ends.
Enter your values to see the result.
Good to know
For a stepped or irregular wall, calculate each section separately.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
The side wall of a lean-to extension is 3.6 m long, 2.1 m high at the front and 2.9 m at the house, with a 900 × 1050 mm window (0.945 m²). A = 3.6 × (2.1 + 2.9) ÷ 2 − 0.945 = 9.0 − 0.945 ≈ 8.06 m². Use about 8.1 m² for the brick or block count on that elevation, plus the usual cutting allowance along the sloping top.
Common questions
Where do I measure the two end heights from?
Measure both from the same level, usually the DPC or the top of the footing, up to where the sloping top meets each end. Mixing a ground-level height at one end with a DPC height at the other throws the average out.
Do I need more waste on a raking wall than a straight one?
Usually yes, because every course along the slope is cut to the rake. Allow extra for those cuts on top of your normal waste figure.
What if the slope starts partway along the wall?
Split it into a rectangle for the level part and a trapezoid for the sloping part, work each separately and add them together.