Roof geometry
Firring strip taper
- where
- rise (mm)
- horizontal length (mm)
- fall denominator (1:n)
- high-end thickness (mm)
- low-end thickness (mm)
- taper angle (°)
Explain this equation
Works out the thicknesses of a tapered firring strip that creates a set fall on a flat roof.
L is the horizontal length of the strip in millimetres. n is the fall denominator, so 1:40 means 1 mm of drop for every 40 mm along. r is the rise over the length. t is the thickness at the low end, and T at the high end. θ is the taper angle.
A 1:n fall changes height by L/n over the length, so the high end is the low end plus that rise. The angle is arctan(1/n), the same slope expressed in degrees.
A 4000 mm strip at 1:40 rises 100 mm, so a 20 mm low end becomes 120 mm. The taper is about 1.4°.
Watch out: the fall must come from the roof design. Allow for deflection, which can reduce the effective fall.
Calculate the geometric high end and taper for a specified fall.
Enter your values to see the result.
Good to know
The designer specifies the fall, supports and roof build-up. This does not account for deflection or choose a compliant design fall.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Firrings for a 3.6 m flat roof run with a design fall of 1:60 and a 25 mm low end: rise = 3600 ÷ 60 = 60 mm, so the high end is 25 + 60 = 85 mm and the taper is atan(1 ÷ 60) ≈ 0.95°. Mark 25 mm and 85 mm at each end of the timber and rip along the line joining them.
Common questions
Can the low end taper to nothing?
It is better not to. A feathered end splits and gives nothing to fix through, so leave a sensible minimum thickness at the low end and take the exact figure from the roof design.
Is the length measured along the slope or level?
Use the horizontal length over which the fall applies. At these shallow falls the difference is tiny, but it should be the plan length of the run, not just the length of timber you have.
Can I get two firrings from one board?
Yes. Ripping a board diagonally gives two identical tapers, so the board needs to be at least the low end plus the high end deep, plus the saw kerf. For this example that is 25 + 85 = 110 mm plus kerf.