Roof geometry
Equal-pitch jack length difference
- where
- line length difference (mm)
- spacing along eaves (mm)
- common pitch (°)
Explain this equation
Gives the difference in length between neighbouring jack rafters running into a hip on an equal-pitch roof.
s is the spacing of the jacks along the eaves, in millimetres. θ is the common pitch. Δ is how much each successive jack changes in line length.
With a 45° hip on plan, moving one spacing along the eaves moves the hip one spacing closer, so each jack's run changes by s. That run is converted to a slope length by dividing by cos θ, just as for a common rafter.
At 400 mm spacing and 30° pitch each jack differs by about 462 mm. A steeper pitch makes the difference bigger.
Watch out: this is the step between jacks, not the length of the first one, and it does not include side cuts.
Calculate theoretical successive common-jack differences at a 45° plan hip.
Enter your values to see the result.
Good to know
Equal pitches and a 90° plan corner only. This gives a difference, not the first jack length, side cut, or cutting allowance.
Limits
Roof lines are theoretical datum-to-datum lengths. They are not fabricated member lengths with ridge, bearing, seat, overhang or fascia details resolved. Equal-pitch hip and jack tools assume a 90-degree plan corner.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Jack rafters at 600 mm centres along the eaves on a 35° equal-pitch hipped roof: Δ = 600 ÷ cos 35° ≈ 732 mm. Once the longest jack is set out, each one towards the corner is 732 mm shorter on its line length.
Common questions
How do I get the first jack length?
Work it out from its run to the hip, or measure it from the set-out. This calculator gives only the step between jacks.
Does the side cut change the length?
The difference applies to the line lengths. The side cut where each jack meets the hip is set separately and is the same angle on each jack.
What if the jacks are not at even spacing?
Use the actual spacing between each pair. The difference scales directly with spacing, so half the spacing gives half the difference.