Cutting & joints
Coving / crown compound angles
- where
- mitre angle (°)
- spring angle to wall (°)
- included corner angle (°)
- bevel angle (°)
Explain this equation
Gives the mitre and bevel settings for cutting coving or crown moulding lying flat on a compound mitre saw.
φ is the spring angle, the angle between the back of the moulding and the wall once fitted. θ is the included corner angle between the walls. α is the mitre (table) setting and β the bevel (blade tilt) setting, both in degrees.
The moulding leans out from the wall, so the joint line is a compound angle in three dimensions. Laying it flat, the trigonometry splits that angle into a turn of the table and a tilt of the blade. The sin, cos and tan terms come from projecting the sprung moulding onto the saw bed.
For a common 38° spring at a 90° corner you get about 31.6° mitre and 33.9° bevel. A 45° spring gives 35.3° and 30°.
Watch out: these are magnitudes only. Left or right, and inside or outside corner, depend on your saw and how the moulding is placed. Always test-cut.
Calculate magnitude of compound settings for crown cut flat.
Enter your values to see the result.
Good to know
Spring is the installed angle between the back of the moulding and the wall, not ceiling. Angles are magnitudes only. Left/right, inside/outside and fence orientation follow the saw/moulding instructions. Test cuts are essential; this is not a universal profile cut list.
Limits
Crown angles are magnitudes for material cut flat, with spring measured to the wall.
Sources
This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.
Worked example
Coving with a 45° spring angle going round a 135° corner in a bay window: mitre = atan[sin 45° ÷ tan 67.5°] ≈ 16.3° and bevel = asin[cos 45° × cos 67.5°] ≈ 15.7°. Set the saw to about 16.3° mitre and 15.7° bevel, then cut a test pair from offcut before cutting the lengths.
Common questions
How do I find the spring angle of my coving?
Hold a short piece in place against the wall and ceiling and measure the angle between its back and the wall with a sliding bevel, or take it from the maker's data. Don't assume it from a different profile.
What if the corner isn't a true 90°?
Measure the actual included angle between the two walls with an angle finder and enter that. Even a couple of degrees out of square is enough to open a visible gap at the joint.
Do I need these settings if I cut the coving nested against the fence?
No. Cut nested at its spring angle against the fence and table, coving only needs a plain mitre of half the corner angle with no bevel. These figures are for cutting it lying flat.