Tradefox

Tradefox – Build Skills

Learn Construction

‹ All carpentry calculators

Roof geometry

Common rafter line length

R=xtanθL=xcosθLt=ocosθ
where
R
rise (mm)
x
horizontal run (mm)
θ
roof pitch (°)
L
rafter line length (mm)
Lt
tail line length (mm)
o
horizontal overhang (mm)
Explain this equation

Gives the theoretical line length of a common rafter from its horizontal run and pitch, including the tail over the eaves.

x is the horizontal run, usually from the wall plate line to the ridge centre line, in millimetres. θ is the roof pitch. R is the vertical rise. L is the rafter line length, and o the horizontal overhang beyond the plate, giving the tail length Lt.

Run, rise and rafter form a right-angled triangle. The rise is x tan θ, and the slope length is the run divided by cos θ. The tail follows the same slope, so it is the overhang divided by cos θ.

A 3000 mm run at 30° has a 1732 mm rise and a 3464 mm line. A 450 mm overhang adds 520 mm, for about 3984 mm in total.

Watch out: these are line lengths on the pitch line. Ridge deductions, birdsmouths and fascia details are separate.

Calculate a common rafter theoretical line from horizontal run and pitch.

mm
degrees
mm

Enter your values to see the result.

Good to know

Run is to the ridge centreline or other stated datum. These are theoretical line lengths, not fabrication lengths; ridge deductions, seat cuts, bearings and fascia details are separate.

Limits

Roof lines are theoretical datum-to-datum lengths. They are not fabricated member lengths with ridge, bearing, seat, overhang or fascia details resolved.

Sources

This is a calculation aid, not a structural design or compliance certificate. Every default is an example, not a specification for your project.

Worked example

A lean-to rafter with a 2350 mm horizontal run at 40° and a 300 mm horizontal overhang: R = 2350 × tan 40° ≈ 1972 mm; L = 2350 ÷ cos 40° ≈ 3068 mm; Lt = 300 ÷ cos 40° ≈ 392 mm; combined line ≈ 3459 mm. A 3.6 m length gives enough over the line length to cut the plumb and seat cuts.

Common questions

Where should I measure the run from?
From the same datum the design uses, usually the outside of the wall plate to the ridge centre line, or to the face of the ledger on a lean-to. Measuring from different points shifts the birdsmouth.

Is the line length the length I cut?
No. It is the theoretical length along the rafter's set-out line. Ridge thickness deductions, plumb cuts and the birdsmouth are added or taken off separately.

How do I check my pitch before cutting all the rafters?
Cut one rafter as a pattern, offer it up and check the seat and plumb cut fit. Once it is right, mark the rest from it.

Scroll to Top
Secret Link