Setting out
Stretcher offset / bond module
- where
- module (mm)
- unit length (mm)
- joint (mm)
- lap offset (mm)
- offset fraction
Explain this equation
This gives the bond module and the setting-out offset for a chosen fraction of it, such as a half lap in stretcher bond or a quarter lap.
l is the unit length and j the joint, both in mm. Their sum m is the module, the distance from one perpend to the next along a course. f is the fraction of the module you want to offset by, for example 0.5 for half bond or 0.25 for quarter bond. e is the resulting offset in mm.
Perpends repeat every module, so offsets between courses are measured as fractions of the module, not of the bare unit length. That is why the joint is added before multiplying by f.
A 215 mm brick with a 10 mm joint gives a 225 mm module, so a half lap is 112.5 mm and a quarter lap is 56.25 mm.
Watch out: this is a setting-out distance, not the length of a cut brick. Check minimum lap and bond requirements in the design.
Calculate a fraction of a coordinating module.
Enter your values to see the result.
Good to know
This is a setting-out offset, not a cut-brick length. Check minimum lap, closers and structural bond requirements in the design.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
A fair-faced blockwork wall in 440 mm blocks with 10 mm joints is to be laid in third bond. m = 440 + 10 = 450 mm and e = 0.3333 × 450 ≈ 150 mm. Mark the perpends of each course 150 mm along from the course below on the gauge rod or the first course, so the pattern steps evenly across the wall.
Common questions
Why is the offset based on the module, not the block length?
Each perpend repeats every unit plus one joint, so the spacing you are dividing up is the module. Using the bare block length would put every offset a few millimetres out, and the error builds up across the wall.
Is a third or quarter bond as strong as half bond?
Smaller laps reduce how much each unit spreads load to the ones below. For structural walls, follow the minimum lap given in the design or the masonry standard rather than choosing a pattern purely for looks.
How do I handle the ends of the wall with an offset bond?
The ends will need cut units or closers to finish square, and their length depends on the pattern. Work out the cuts before you start so they are consistent course to course.