Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Setting out

Brickwork CO− / CO / CO+

CO=n(l+j)CO−=CO−jCO+=CO+j
where
CO
coordinating size (mm)
n
full stretcher modules
l
brick length (mm)
j
perpend joint (mm)
Explain this equation

This gives coordinating sizes for brickwork, so that piers, panels and openings are dimensioned to whole bricks and avoid cutting.

n is the number of full stretcher modules, l is the brick length and j is the perpend joint, all in mm. One module is a brick plus one joint, l + j. CO is n of those modules. CO− has one joint fewer, which is the size of a pier or panel with free ends. CO+ has one joint more, which is the size of an opening between two pieces of brickwork.

A run of n bricks always contains n bricks and either n − 1, n or n + 1 joints, depending on what is at the ends. Subtracting or adding one joint to CO gives the other two cases.

With 215 mm bricks and 10 mm joints a module is 225 mm. Four modules give a 900 mm CO, an 890 mm pier and a 910 mm opening.

Watch out: this covers full bricks only. It does not deal with corners, half-bat bonds or specials.

Calculate three boundary conditions for a number of full stretcher modules.

mm
mm

Enter your values to see the result.

Good to know

Use the boundary condition shown on the drawing. This full-unit calculator does not automatically resolve corners, half-unit bonds or specials.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

Sizing a window opening in a facing brick wall to suit seven whole bricks of 215 mm with 10 mm perps. CO = 7 × (215 + 10) = 1575 mm, CO− = 1575 − 10 = 1565 mm and CO+ = 1575 + 10 = 1585 mm. Set the structural opening at 1585 mm so the brickwork either side runs to full bricks, and pick a frame that fits that opening rather than the other way round.

Common questions

Which size do I use for a pier between two windows?
A pier has brick at both ends and no joint at either side, so it is CO−. A pier of four bricks with 215 mm bricks and 10 mm joints works out at 890 mm.

The drawing has an opening that is not a CO size. What can I do?
Ask whether the opening can move to the nearest CO+ size, as a few millimetres either way usually makes no difference to the frame. If it cannot, plan the cut bricks so they fall in the least visible place, such as under a sill.

Does this work for blockwork too?
Yes, the same rule applies with the block length and joint, for example 440 mm blocks with 10 mm joints give a 450 mm module. Enter the block length instead of the brick length.

Scroll to Top
Secret Link