Quantities
Rectangular wall + triangular gable
- where
- net wall area (m²)
- width (m)
- eaves height (m)
- gable rise (m)
- openings (m²)
Explain this equation
This works out the net face area of a gable end: a rectangular wall up to the eaves with a straight-sided triangle on top, less any openings. Use it when ordering units for a gable wall.
b is the width of the wall, h is the height up to the eaves and r is the gable rise, measured vertically from the eaves to the apex. A_o is the total area of openings in the whole face.
The face splits into two shapes. b × h is the rectangle below the eaves. The gable is a triangle with base b and height r, and any triangle is half of the rectangle around it, hence b × r / 2.
A 6 m wide wall, 2.4 m to the eaves with a 1.5 m rise, is 14.4 + 4.5 = 18.9 m²; less 2 m² of openings leaves 16.9 m².
Watch out: r is the vertical rise, not the length of the sloping verge. Other shapes need splitting up.
Calculate a symmetrical or off-centre triangular gable above a rectangular wall.
Enter your values to see the result.
Good to know
Gable rise is measured vertically above the eaves. Only use this for straight-sided triangular gables.
Sources
Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.
Worked example
The gable end of a two-storey house is 7.4 m wide, 5.1 m from DPC to eaves, with a 2.6 m rise to the apex and two 1.2 × 1.2 m windows (2.88 m²). A_net = 7.4 × 5.1 + 7.4 × 2.6 ÷ 2 − 2.88 = 37.74 + 9.62 − 2.88 ≈ 44.5 m². That is the facing area to order for, with extra for the raking cuts up both verges.
Common questions
Where does the eaves height stop and the gable start?
Measure the rectangle up to the level where the roof slope begins on the gable, usually in line with the wall plate on the side walls. Everything above that line is the triangle.
How do I find the gable rise without going up a ladder?
You can work it out from the roof pitch: rise = half the width × tan(pitch). For a 35° roof on this 7.4 m gable that would be about 3.7 × 0.70 ≈ 2.6 m.
Should the verge overhang or bargeboard be included?
No. Count only the brickwork face. Bargeboards, soffits and any tiled verge are separate items, and on a brick-on-edge or dentil verge you may need specials counted separately.