Tradefox

Tradefox – Build Skills

Learn Construction

‹ All bricklaying calculators

Quantities

Wall area less openings

Agross=lhAnet=Agross−Ao
where
Agross
gross wall area (m²)
l
length (m)
h
height (m)
Anet
net wall area (m²)
Ao
total openings (m²)
Explain this equation

This gives the area of one flat wall face, before and after taking out windows, doors and other openings. It is usually the first step in pricing or ordering bricks, blocks or mortar for a wall.

l is the length along the wall and h is its height, so l × h is the whole rectangle of the face, A_gross. A_o is the combined area of every opening in that face, entered as one total. A_net is the brickwork actually laid.

A rectangle's area is simply length times height, and the openings are holes in it, so they are subtracted. Everything is in metres, so the answers come out in m².

A 5 m wall 2.4 m high is 12 m² gross; take out a 2 m² window and you lay 10 m². Doubling the length doubles the gross area, but the openings stay the same, so the net area more than doubles.

Watch out: reveals, returns and recesses are extra surfaces and are not included. The calculator stops if A_o is larger than the gross area.

Measure one flat wall face and deduct the combined area of its openings.

m
m
m²

Enter your values to see the result.

Good to know

Enter the total opening area once. Reveals, returns and recesses are separate surfaces.

Sources

Estimates are not design approval or British Standards compliance checks. Structural arch, retaining-wall, wind, foundation, lintel and masonry-capacity design are not performed. Use the project engineer’s specification.

Worked example

The rear elevation of a single-storey extension is 7.8 m long and 2.55 m from DPC to wall plate, with a 2.4 × 2.1 m bifold opening and a 1.2 × 1.05 m window, 6.3 m² of openings in total. A_gross = 7.8 × 2.55 ≈ 19.9 m² and A_net = 19.9 − 6.3 ≈ 13.6 m². Price and order the facing bricks on 13.6 m², then add the reveals and any piers separately.

Common questions

Should I measure openings to the frame size or the structural opening?
Use the structural opening in the brickwork, which is usually a little bigger than the frame. That is the hole the bricks stop at, so it gives the right net area.

Is it worth deducting small openings like air bricks?
Not usually. Small items such as air bricks and meter boxes cost cutting time rather than saving bricks, so most estimators leave them in the area.

Do I measure the length on the outside or inside face?
For facing brick, measure the outside face. For the inner block leaf, use the inside face, which is shorter at each corner by roughly the wall thickness.

Scroll to Top
Secret Link